Water based acrylic modified silicone sealer, which penetrates into the pavers and provides a hydrophobic coating.

• It can inhibit the algae and mold with good abrasion resistant.

Main advantages:

• Very safe for human and the environment
• Can be applied on even wet floor surfaces
• Wet-look and glossy top coat film
• Exellent joint stabilization, and no need for polymeric sand
• Algae and mold inhibitor
• High durability

​Uses :

Used for coating hardened concrete floor, brick, stone, paver, and other types of hardened floor surfaces.

Clean surface to make sure there is no oil, efflorescence, laitance or contaminants.

Can be applied even though the pavers are wet.

It cannot be applied on pavers in standing water, as the sealer will not cure and stabilize the joint sand.

It is recommended that multiple coats for extremely absorbent pavers.

Use battery operated pail pump system or pump sprayer to evenly apply a floodcoat of sealer for joint stabilization. Hold sprayer tip 10” –12” from the paver surface (avoid overspray on adjacent surfaces, rinse any overspray with water).

Sealer appears white when applied but dries crystal clear. Make sure to apply sealer consistently to prevent blotching. (Back rolling is recommended for consistency).

As for pavers with polymeric sand, we recommend two even consistent coats of sealer without flooding the paver joints.

Use a leaf blower to blow out any excessive sealer that puddles in the paver joints or low lying areas with textured pavers and or natural stone. Excess sealer may be stored for future use.